Nesco Resource is sourcing for Injection Mold Machine Operator for our long-term client in Chesterfield, MI. This is a contract to hire job opportunity.
Shift :
8:00am to 4:30pm for training, after training 6:00am to 2:30pm (overtime based upon production needs).
Machine description :
Vertical indexing injection molding machine. Manually loaded and unloaded. Two cavities per mold, two molds 180 degrees apart on indexing table. Plastic used is PPS resin. Mold is heated to high temperature. Metal and plastic components are manually loaded onto mold before cycling, and manually removed after cycling.
Injection Molding Machine Operator key tasks:
- Add plastic resin pellets to dryer as needed
- Prepare injection molding machine for daily operation
- Verify machine settings as needed
- Purge plastic resin from cylinder and hot runner system
- Run initial trial shots to confirm machine is ready for mass production
- Clean our debris from molds by using air blow
- Visually inspect components to confirm they are prepared properly for over-molding
- Manually load components into mold cavities for over-molding
- Visually confirm components are loaded properly and mold details are in correct position
- Initiate start of cycle by pushing button
- Observe molding process to make sure parts are properly ejected after completion of cycle
- Remove and visually inspect completed parts
- Pack completed parts in totes after cool down period
Nesco Resource provides equal employment opportunities to all employees and applicants for employment and prohibits discrimination and harassment of any type without regard to race, color, religion, age, sex, national origin, disability status, genetics, protected veteran status, sexual orientation, gender identity or expression, or any other characteristic protected by federal, state, or local laws.